Solar UPS: SO10192

SO10192
Type MPPT SOLAR CHARGE CONTROLLER
Model SO10192
INPUT
Input Voltage Range 100V ~ 300V (Wide input voltage range)
180V ~ 260V (Normal input voltage range)
Nominal Input Voltage(s) Supported 220V AC , 50Hz
Input connection type Hard Wire
BATTERY Full Load Runtime (minutes) Depends on Load & Battery AH
No of Battery 16
Solar Charge Controller
Type MPPT/PWM
Max.PV Open Circuit Array Volatge 352VDC
Charge Algorithm 3-stage Bulk / Acceptance / Float Plus Equalize
LCD Display Backlit, Alphanumeric Display showing battery voltage, DC amperage, Cumulative KW hours
OUTPUT
Output Volt Amp Capacity (VA) 10000
Output Watt Capacity (watts) 8000W
DC System Voltage (VDC) 192V
Load Capacity >110% faulty after 300ms
Phases 1Phase – 3 Wire (L.N.E)
Output AC waveform Pure Sine Wave
Efficiency > 88%
GENERAL
LCD / LEDs Indications UPS ON (Yellow), Battery Low (Red), Mains ON (Green),Charging (Green), Overload(Red)
Alarms Audible alarm indicates power failure and overload conditions
Switches 1)Switch control off / on power status
2)Switch for mains input voltage range
3)Switch to select the maximum charging voltage
Protection > 300% Load (with manual reset function)
Cooling Method Forced air cooled
Transfer Time Battery to line mode : 300 milliseconds / Line to battery mode : 300 milliseconds
Housing Material Powder coated / painted MS
ENVIRONMENTAL
Operating Temperature Range 0°C to 50°C
Relative Humidity 95% (non-condensing)
Degree of Protection IP 20
BATTERY
No of Battery 16
Battery Charging Profile(Boost /Foat) Suitable according to Battery type (eg :VRLA/SMF/Wet Lead Acid Battery)
Max Charging Current(when battery is fully discharge) 10A ±2amp
SPECIAL FEATURES
Cold Start (startup in battery mode during a power failure) Cold-start operation supported
Charge End Voltage Grid charging stop when battery reaches 13.8V ±0.2V and transfer to backup mode (per battery)
Grid Recharge Voltage Grid charging starts when battery reaches 11V ±0.2V and transfer to grid (per battery)
CERTIFICATIONS
Quality Certifications ISO 9001:2008
WARRANTY
Product Warranty Period 1 – year limited warranty
Since we are committed to continuous development of our products, the specification are subject to change without notice.

Specifications

Bookmark the permalink.